Metabolic equivalent

From Infogalactic: the planetary knowledge core
Jump to: navigation, search

Lua error in package.lua at line 80: module 'strict' not found.

The Metabolic Equivalent of Task (MET), or simply metabolic equivalent, is a physiological measure expressing the energy cost of physical activities and is defined as the ratio of metabolic rate (and therefore the rate of energy consumption) during a specific physical activity to a reference metabolic rate, set by convention to 3.5 ml O2·kg−1·min−1 or equivalently:

\text{1 MET}\ \equiv\ 1 \dfrac{\text{kcal}}{\text{kg}*{h}}\ \equiv\ 4.184 \dfrac{\text{kJ}}{\text{kg}*{h}}

1 MET is also defined as 58.2 W/m2 (18.4 Btu/h·ft2), which is equal to the rate of energy produced per unit surface area of an average person seated at rest. The surface area of an average person is 1.8 m2 (19 ft2). Metabolic rate is usually expressed in terms of unit area of the total body surface (ANSI/ASHRAE Standard 55[1]).

Originally, 1 MET was considered as the Resting Metabolic Rate (RMR) obtained during quiet sitting.[2][3] MET values of activities range from 0.9 (sleeping) to 23 (running at 22.5 km/h or a 4:17 mile pace).

Although the RMR of any person may deviate from the reference value,[4][5] MET can be thought of as an index of the intensity of activities: for example, an activity with a MET value of 2, such as walking at a slow pace (e.g., 3 km/h) would require twice the energy that an average person consumes at rest (e.g., sitting quietly).

MET is used as a means of expressing the intensity and energy expenditure of activities in a way comparable among persons of different weight. Actual energy expenditure (e.g., in calories or joules) during an activity depends on the person's body mass; therefore, the energy cost of the same activity will be different for persons of different weight. However, since the RMR is also dependent on body mass in a similar way, it is assumed that the ratio of this energy cost to the RMR of each person will remain more or less stable for the specific activity and thus independent of each person's weight.[citation needed]

The 1 MET reference value of 1 kcal·kg−1·h−1, is used by convention and refers to a typical metabolism at rest of an "average" individual. It must not be confused or misused as an approximation of Basal Metabolic Rate (BMR), which is the minimum metabolic rate obtained under specified conditions. This is illustrated by the fact that sleeping has a MET of 0.9, while an individual's normal sleeping metabolism may be greater than the BMR.

Compendium of Physical Activities

The Compendium of Physical Activities was developed for use in epidemiologic studies to standardize the assignment of MET intensities in physical activity questionnaires. Dr. Bill Haskell from Stanford University conceptualized the compendium and developed a prototype for the document. The compendium was used first in the Survey of Activity, Fitness, and Exercise (SAFE study - 1987 to 1989) to code and score physical activity records. Since then, the compendium has been used in studies worldwide to assign intensity units to physical activity questionnaires and to develop innovative ways to assess energy expenditure in physical activity studies. The compendium was published in 1993 and updated in 2000 and 2011.[6]

Scope of usage of the MET concept

Epidemiology and public health

MET (Metabolic Equivalent): The ratio of the work metabolic rate to the resting metabolic rate. One MET is defined as 1 kcal/kg/hour and is roughly equivalent to the energy cost of sitting quietly. A MET also is defined as oxygen uptake in ml/kg/min with one MET equal to the oxygen cost of sitting quietly, equivalent to 3.5 ml/kg/min.

The MET concept was primarily designed to be used in epidemiological surveys, where survey respondents answer the amount of time they spend for specific physical activities.[3]

Moreover MET is used to provide general medical thresholds and guidelines to a population.[7][8] A MET is the ratio of the rate of energy expended during an activity to the rate of energy expended at rest. For example, 1 MET is the rate of energy expenditure while at rest. A 4 MET activity expends 4 times the energy used by the body at rest. If a person does a 4 MET activity for 30 minutes, he or she has done 4 x 30 = 120 MET-minutes (or 2.0 MET-hours) of physical activity. A person could also achieve 120 MET-minutes by doing an 8 MET activity for 15 minutes.[9]

Physical activity MET
Light intensity activities < 3
sleeping 0.9
watching television 1.0
writing, desk work, typing 1.5
walking, 1.7 mph (2.7 km/h), level ground, strolling, very slow 2.3
walking, 2.5 mph (4 km/h) 2.9
Moderate intensity activities 3 to 6
bicycling, stationary, 50 watts, very light effort 3.0
walking 3.0 mph (4.8 km/h) 3.3
calisthenics, home exercise, light or moderate effort, general 3.5
walking 3.4 mph (5.5 km/h) 3.6
bicycling, <10 mph (16 km/h), leisure, to work or for pleasure 4.0
bicycling, stationary, 100 watts, light effort 5.5
sexual activity 5.8[10]
Vigorous intensity activities > 6
jogging, general 7.0
calisthenics (e.g. pushups, situps, pullups, jumping jacks), heavy, vigorous effort 8.0
running jogging, in place 8.0
rope jumping 10.0

Limitations in the usage of MET to calculate actual energy expenditure

Lua error in package.lua at line 80: module 'strict' not found. Published MET values (or exercise calorie calculators on web sites, which are based on such values) for specific activities are experimentally and statistically derived from a sample of persons and are indicative averages. The level of intensity at which a specific person performs a specific physical activity (e.g., the pace of walking, the speed of running, etc.) will deviate from the representative experimental conditions used for the calculation of the standard MET values. Moreover, as is explained in the following, the actual energy expenditure and the RMR will differ according to the person's overall fitness level and other factors.

The same holds for MET (or kcal) values indicated in modern fitness exercise equipment, which are based on statistical models and are of indicative value only. In this case, even if the MET value indicated is a better statistical prediction than published tables, there is no way to account for the person's actual RMR and thus energy expenditure (e.g., Kcal). In short, a person can use the MET concept to plan or monitor physical activity levels or get an indication of the aerobic intensity and order of magnitude of energy expenditure for a specific activity, but not use the MET concept to calculate actual energy expenditure or a daily energy input-output balance.

More specifically, from a strictly scientific point of view, statistically estimated predictions, such as MET or BMI, are inaccurate when used for specific persons, and MET values must be treated as indicative only, taking into account that both RMR and actual energy consumption are highly dependent on physical and environmental factors such as adiposity, physical fitness level, cardiovascular health, or even ambient temperature.

Moreover, even the definition of MET is problematic when used for specific persons.[4][5] By convention, 1 MET is considered equivalent to the consumption of 3.5 ml O2·kg−1·min−1 (or 3.5 ml of oxygen per kilogram of body mass per minute) and is roughly equivalent to the expenditure of 1 kcal per kilogram of body weight per hour. This value was first experimentally derived from the resting oxygen consumption of a particular subject (a healthy 40-year-old, 70 kg man) and must therefore be treated as a convention. Since the RMR of a person depends mainly on lean body mass (and not total weight) and other physiological factors such as health status, age, etc., actual RMR (and thus 1-MET energy equivalents) may vary significantly from the kcal/(kg·h) rule of thumb. RMR measurements by calorimetry in medical surveys have shown that the conventional 1-MET value overestimates the actual resting O2 consumption and energy expenditures by about 20% to 30% on the average, whereas body composition (ratio of body fat to lean body mass) accounted for most of the variance.

See also

References

Sources

  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.

External links