Peak coal

From Infogalactic: the planetary knowledge core
Jump to: navigation, search

According to M. King Hubbert's Hubbert peak theory, Peak coal is the point in time at which the maximum global coal production rate is reached, after which, according to the theory, the rate of production will enter a terminal decline. Coal is a fossil fuel formed from plant matter over the course of millions of years. It is a finite resource and thus considered to be a non-renewable energy source.

There are two different possible peaks: one measured by mass (i.e. metric tons) and another by energy output (i.e. petajoules). The world average heat content per mass of mined coal rose from 8,020 BTU/lb. in 1989 to 9,060 BTU/lb. in 1999. Since 1999, the world average heat content of mined coal has been fairly steady, and was 9,030 BTU/lb. in 2011.[1]

The estimates for global peak coal extraction vary wildly. Many coal associations suggest the peak could occur in 200 years or more, while scholarly estimates predict the peak to occur as soon as the immediate future. Research in 2009 by the University of Newcastle in Australia concluded that global coal extraction could peak sometime between the present and 2048.[2] A 2007 study by the German Energy Watch Group predicted that global peak coal extraction may occur sometime around 2025 at 30 percent above the 2005 rate.[3][4]

Hubbert's theory

The contemporary concept of peak coal follows from Hubbert peak theory,[citation needed] which is most commonly associated with Peak oil. Hubbert concluded that each oil region and nation has a Bell-shaped depletion curve.[5] However, this question was originally raised by William Stanley Jevons in his book The Coal Question back in 1865.

Hubbert noted that United States coal extraction grew exponentially at a steady 6.6% per year from 1850 to 1910. Then the growth leveled off. He concluded that no finite resource could sustain exponential growth. At some point, the rate of extraction will have to peak and then decline until the resource is exhausted. He theorized that extraction rate plotted versus time would show a bell-shaped curve, declining as rapidly as it had risen.[6] Hubbert used his observation of the US coal extraction to predict the behavior of peak oil.

The Hubbert Linearization using yearly production rates has weaknesses for peak coal calculation, as the signal-to-noise ratio is inferior with coal mining data compared to oil extraction. As a consequence, Rutledge[7] uses cumulative production for linearization. By this method the estimated ultimate recovery results in a stable fit for active coal regions. The ultimate production for world coal is estimated to be 680 Gt, of which 309 Gt have already been produced. However, in 2013 the World Coal Association reported that two different estimates of coal reserves remaining were 1038 and 861 Gt.[8]

Peak coal for individual nations

Coal production trends 1980-2012 in the top five coal-producing countries (US EIA)

As of 2011, the top coal-extracting countries were China (46% of world extraction), United States (13%), India (7.8%), Australia (5.4%), and Indonesia (4.9%). Four out of five of these largest coal-extracting countries, the exception being the United States, had experienced significant increases in coal extraction over the previous decade.[9]

People's Republic of China

The People's Republic of China is the world’s largest coal extractor and has the third largest reserves after Russia and the United States. The Energy Watch Group predicts that the Chinese extraction will peak around 2015.[3] The EWG also predicts that the recent steep rise in extraction will be followed by a steep decline after 2020. Another study puts the peak at 2027.[10] The US Energy Information Administration projects that China coal extraction will continue to rise until 2030.[11]

United States

File:US coal production.png
US coal production had major tonnage peaks in 1918, 1947, and 2008.
File:US Coal Tonnage and BTU.png
United States annual mined coal tonnage (black) and BTU content (red), 1980-2012, from US EIA.
  • Expected total peak extraction (Hubbert, 1956): ~2150[5]
  • Peak coal energy output: 1998[3][12]

Coal mass

US coal extraction peaked during World War I, then declined sharply during the depression years of the 1930s. Coal extraction peaked again in the 1940s, then declined during the 1950s.[5] Then coal extraction revived, and has been on a nearly continual increasing trend since 1962, exceeding the previous peaks. Extraction in 2006 was a record 1.16 billion short tons.[13] High-BTU anthracite coal peaked in 1914;[5] and declined from 44 million tons in 1950 to 1.6 million tons in 2007. Bituminous coal extraction has also been declining since 1990. The gap has been taken up by large increases in subbituminous coal extraction.[13] Comprehensive analysis of historical trends in US coal extraction and reserve estimates, along with a possible future outlook, has recently been published in scientific journals on coal geology.[14]

In 1956, Hubbert estimated that US coal extraction would peak in about the year 2150.[5] In 2004, Gregson Vaux used the Hubbert model to predict peak US coal extraction in 2032.[15] In 2014, a model published in the International Journal of Coal Geology forecast a U.S. raw tonnage peak from between 2009 and 2023, with the most likely year of the peak in 2010.[16]

Energetic peak

Over the years, the average energy content per ton of coal mined in the US has declined as mining shifts to coals of lower rank. Although the tonnage of coal mined in the United States reached its latest peak in 2008, the peak in terms of coal energy content occurred in 1998, at 598 million tons of oil equivalents (Mtoe); by 2005 this had fallen to 576 Mtoe, or about 4% lower.[3][12]

Australia

Australia has substantial coal resources, mostly brown coal. It is responsible for almost 40% of global coal exports worldwide, and much of its current electricity is generated from coal-fired power stations. There are tentative plans to very slowly phase out coal electricity generation in favor of gas, although these plans are still a topic of much debate in Australian politics.

Long-term plans for coal in Australia include large-scale export of brown coal to large developing nations such as China and India.[17] Other groups such as the Australian Greens, suggest that coal be left in the ground to avoid its potential combustion either in Australia or in importer nations.

Research in 2009 by the University of Newcastle in Australia concluded that Australian coal extraction could peak sometime after 2050.[2] While the Australian Coal Association (ACA) optimistically estimates that Australia's identified black coal resources could last more than 200 years based on rate of extraction in 2007. This does not account for brown coal stocks.[18]

New South Wales

According to calculations conducted for the Hunter Community Environment Centre in Newcastle, the Australian state of New South Wales 10,600 million tonnes of coal reserves would be exhausted by 2042, based on current industry growth and extraction rates of about 3.2 per cent a year.[18]

United Kingdom

Coal output peaked in 1913 in Britain at 287m tons and now accounts for less than one percent of world coal extraction. 2007 extraction was around 15m tons.[19]

Canada

According to the Earth Watch Group, Canadian coal extraction peaked in 1997.[3]

Germany

Germany hit peak hard coal extraction in 1958 at 150 million tons. In 2005 hard coal extraction was around 25 million tons.[3] Total coal extraction peaked in 1985 at 578 million short tons, declined sharply in the early 1990s following German reunification, and has been nearly steady since 1999. Total coal extraction in 2005 was 229 million short tons, four percent of total world extraction.[9]

World peak coal

File:World Coal Tonnage and BTU.png
World coal production in tonnage (black) and BTU content (red), 1980-2011; data from US EIA.
  • 2011 Patzek and Croft

In 2010, Tadeusz Patzek (chairman of the Department of Petroleum and Geosystems Engineering at the University of Texas at Austin) and Greg Croft, predicted that coal production would peak in 2011 or shortly thereafter, and decline so quickly as to nearly eliminate the contribution of coal to climate change.[20]

  • 2150 M. King Hubbert

M. King Hubbert's 1956 projections from the world extraction curve estimated that world coal production would peak at approximately six billion metric tons per year at about the year 2150.[21]

  • 2025 Energy Watch Group

Coal: Resources and Future Production,[3] published on 5 April 2007 by the Energy Watch Group (EWG) found that global coal extraction could peak in as few as 15 years.[22] Reporting on this, Richard Heinberg also notes that the date of peak annual energetic extraction from coal will likely come earlier than the date of peak in quantity of coal (tons per year) extracted as the most energy-dense types of coal have been mined most extensively.[23]

  • Institute for Energy

The Future of Coal by B. Kavalov and S. D. Peteves of the Institute for Energy (IFE), prepared for European Commission Joint Research Centre, reached conclusions similar to those of Energy Watch Group, and stated that "coal might not be so abundant, widely available and reliable as an energy source in the future".[22] Kavalov and Peteves did not attempt to forecast a peak in extraction.

  • US Energy Information Administration projects world coal consumption to increase through 2035.[24]

See also

References

  1. US EIA, International Energy Statistics, accessed 16 May 2015.
  2. 2.0 2.1 Lua error in package.lua at line 80: module 'strict' not found.
  3. 3.0 3.1 3.2 3.3 3.4 3.5 3.6 Lua error in package.lua at line 80: module 'strict' not found.
  4. Lua error in package.lua at line 80: module 'strict' not found.
  5. 5.0 5.1 5.2 5.3 5.4 Lua error in package.lua at line 80: module 'strict' not found.
  6. Lua error in package.lua at line 80: module 'strict' not found.
  7. Lua error in package.lua at line 80: module 'strict' not found.
  8. Lua error in package.lua at line 80: module 'strict' not found.
  9. 9.0 9.1 Lua error in package.lua at line 80: module 'strict' not found.
  10. Lua error in package.lua at line 80: module 'strict' not found.
  11. Lua error in package.lua at line 80: module 'strict' not found.
  12. 12.0 12.1 Lua error in package.lua at line 80: module 'strict' not found.
  13. 13.0 13.1 US Energy Information Agency: Coal production, selected years, 1949-2007
  14. Lua error in package.lua at line 80: module 'strict' not found.
  15. Lua error in package.lua at line 80: module 'strict' not found.
  16. Lua error in package.lua at line 80: module 'strict' not found.
  17. Lua error in package.lua at line 80: module 'strict' not found.
  18. 18.0 18.1 Lua error in package.lua at line 80: module 'strict' not found.
  19. Lua error in package.lua at line 80: module 'strict' not found.
  20. Patrick Reis, "Study: World's 'Peak Coal' Moment Has Arrived", New York Times, 29 Sept. 2010.
  21. Lua error in package.lua at line 80: module 'strict' not found.
  22. 22.0 22.1 Lua error in package.lua at line 80: module 'strict' not found.
  23. Lua error in package.lua at line 80: module 'strict' not found.
  24. Lua error in package.lua at line 80: module 'strict' not found.

Further reading

  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.