1937 Pattern Web Equipment

From Infogalactic: the planetary knowledge core
Jump to: navigation, search
File:LEG 13DBLE 1942.jpg
Uniform of the Légionnaires during the Battle of Bir Hakeim (1942). Note the 37 Pattern Webbing, Basic Pouches, and Sten submachine gun.

1937 Pattern Web Equipment (also known as '37 Webbing') was an item of military load-carrying equipment. It replaced the 1908 Pattern and 1925 Pattern—on which it was based—and was standard issue for British and Commonwealth troops from its introduction in 1937, throughout World War II, and in the post-war period until it was superseded by 58 pattern webbing.

Development

During the 1930s the introduction of new weapons such as the Bren light machine gun and the planned mechanisation of the British Army led to the need for the development of a new design for the Army's basic load carrying equipment.[1] The introduction of the weapons with high rates of fire meant that soldiers had a requirement to carry more ammunition than previously, while mechanisation meant that soldiers had to be able to move freely within the confines of their vehicles.[1] The increasingly complex nature of combat and different roles that soldiers and members of the other services were being required to undertake, meant that the new design needed to be flexible, thus it was decided that it would consist of interchangeable components, which could be modified to suit the individual needs of a soldier based on his role.[1]

The design was confirmed on 8 June 1938 and wide-scale issue began in 1939.[1] Towards the end of World War II, some 37 Webbing was produced in jungle green for troops fighting in the Pacific Theatre, although purpose-made 44 Pattern Webbing was then introduced for the humid jungle conditions, being lighter in weight, quicker drying and rot-proofed.[2] Although 44 Pattern continued in use with the British Army for jungle warfare in its various post-World War II colonial conflicts, it did not replace 37 Pattern in general service, which was in use up until the introduction of 58 Pattern. However, 37 Pattern was used for ceremonial purposes and still issued to Cadets in the 1990s.[citation needed]

Description

1937 Pattern Webbing was made from cotton webbing, which was waterproofed and dyed before being woven.[3] The fittings were made of stamped brass—blackened steel post war—and it was produced by various manufacturers. It was produced in a khaki colour for the Army, which could then be dyed with Blanco, most often to Pea Green (a light-green shade) and blue-grey for the Royal Air Force (the latter using the earlier 1925 issue ammunition pouch and holster for their issued revolvers in conjunction with 37 Pattern gear).[citation needed] Military Police blancoed their webbing white.[4]

Shades of blanco as used on 1937 Pattern web belts:
White (Military Police)
Black (Rifles)
Khaki (Untreated / Desert)
Pea Green (Europe)
Jungle Green (Far East)

Standard components included a belt (issued in sizes Normal and Large), cross straps, cartridge pouches for .303 ammunition (which gave way to 'universal' pouches to carry ammunition for an array of infantry weapons then in use by the British Army, in addition to grenades), a carrier for the waterbottle and a small pack.[5] The large (1908) pack—intended to be carried in regimental transport except when in full marching order—and entrenching tool carrier were retained from World War I issue, although the later was initially issued in modified form before being reintroduced in 1941.[6] Frogs for the 1907 SMLE and No.4 Rifle bayonets were also issued.[7] Different combinations of these components comprised the 'marching order' and the 'battle order' respectively. In addition various items were issued to be used by officers and often armoured crewmen, such as pouches for binoculars, pistol ammunition and compass (externally the same as that for pistol ammunition but with felt padding inside), as well as a 'valise' side pack and holster for the .38 revolver (a tank crew version with leg strap also existed in two versions).[8][9]

A number of items were issued which conformed to 37 Pattern in their fittings and materials but were not strictly part of the set, such as a bandolier for Sten magazines as issued to airborne troops and the spare barrel bag and parts wallet for the Bren gun.[10]

Components

Basic Components

  • Haversack, All Ranks: A rectangular bag that attached to the suspenders on the left hip. It was partitioned in the middle and the rear partition was split in two, with the two Mess Tins stored in one side and the Mark VII Water Bottle and its webbing harness stored in the other side.
  • Binoculars Case: A box that carried the Binoculars Pouch and binoculars. The back of the case slid on the web belt with two long oval metal hooks. The same case could also be used for carrying the iron sight for the tripod-mounted BREN gun; it came in a fitted wooden box to cushion and protect it.
  • Compass Pouch: A square pouch that was the same size and shape as the pistol ammunition pouch except it was felt-lined to cushion the compass. It connected the Binoculars Case to the right-side shoulder strap.

Holsters

  • Pistol Case: A cross-draw belt holster worn on the left hip that was designed to carry the Enfield No 2 Revolver.
  • Pistol Case, Royal Tank Corps (1916-1939) / Royal Armoured Corps (1939-Present): A straight-draw thigh holster worn on the right thigh that was used by Tank commanders to carry the Enfield No 2 Revolver. It had a long strap that allowed it to extend to the upper leg and a tie-down strap on the holster to secure it. It had six cartridge loops on the side of the holster to hold spare ammunition and a cleaning rod pocket along the front edge. There are pictures showing Commandos wearing a cross-draw shoulder holster worn under the left armpit made from a converted version of this rig.

Ammunition Carriers

The system could be used to flexibly mix and match components, but regulations usually had soldiers wear set combinations.

  • Grenade Carrier: A horizontal rectangular case with two pouches. Each pouch could carry a No 36M Mills Bomb Fragmentation Grenade. The back of the carrier slid on the web belt with two long oval metal hooks. It was designed to be worn on the side of the belt on the hip rather than the front and therefore has no shoulder strap link.
  • Basic Pouch: A large vertical rectangular pouch that went through three versions (Marks I, II, and III). It could carry either (2) BREN magazines, (6) 20-round Thompson SMG magazines, (4) No 36M Fragmentation, No 69 Offensive, or No.77 White Phosphorus grenades, (4) No 36M cup-discharger rifle grenades with attached gas-check baseplates, (2) Smoke Grenades, or boxes of Small Arms Ammunition. The Mark I version had three cartridge loops sewn into the inner lid for carrying three ballistite Rifle Grenade Blanks for launching rifle grenades; this feature was later omitted on the Mark II pouch. The longer Basic Pouch Mark III could hold (5) 32-round STEN Machine Carbine Magazines.
  • Pistol Ammunition Pouch: A small pouch that carried a rectangular box of (12) rounds of .38/200 ammunition for the Enfield No 2 Revolver. It could be secured between the Pistol Case and the left suspender.
  • Cartridge Carrier: A horizontal rectangular case with two square pouches that carried a total of 20 rounds (4 x 5-round clips). It was designed for use by soldiers who carried a rifle. Each pouch contained (2) 5-round Mauser-style stripper clips (called "chargers" in British parlance) that were separated by a cloth divider. The pouch had two snaps: the bottom snap was used if only one clip was carried and the top snap was used if both clips were carried. The back of the carrier slid on the web belt with two long oval metal hooks and the top had a strap that linked into the shoulder strap.
  • Lanchester Magazine Pouch: This long rectangular pouch carried (3) 50-round magazines for the Lanchester Machine Carbine that was used by the Royal Marines, Royal Navy and RAF. The back of the carrier slid on the web belt with two long oval metal hooks and the top had a short strap that linked into the shoulder strap. It was so high that it went almost up to the wearer's chin.
  • Vickers G.O. Gun Magazine Pouch, Alternate: This was an oval pouch designed to hold a drum for the Vickers K "Gas Operated" machinegun. It could hold a 100-round drum. The back of the carrier slid on the web belt with two long oval metal hooks and the top had a strap that linked into the shoulder strap.

Accessories

  • Bandolier: A rectangular piece of cloth with 5 pockets and a shoulder strap. Each pocket carried (2) 5-round Mauser-style stripper clips for a total of 50 rounds. It went through 3 marks and 4 versions during the war (Marks I, II, III, and III/1).
  • Utility Pouch: A pair of large vertical rectangular pouches with a built-in cloth yoke and a narrow strap for securing across the chest. It was a bigger version of the Basic Pouch. The yoke could be worn over the neck and the pouches across the chest or worn over the shoulder with the pouches across one side. Each pouch could carry either (3) BREN gun magazines, (2) Boys Anti-Tank Rifle magazines, (3) 2-inch O.S.B. mortar shells, a Mark VII water bottle, several grenades, or boxes of Small Arms Ammunition.

Notes

  1. ↑ 1.0 1.1 1.2 1.3 Brayley & Chappell 2001, p. 38.
  2. ↑ Brayley & Chappell 2002, p. 37.
  3. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  4. ↑ Brayley & Chappell 2001, p. 44.
  5. ↑ Brayley & Chappell 2001, p. 39.
  6. ↑ Brayley & Chappell 2001, pp. 38–39.
  7. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  8. ↑ Brayley & Chappell 2001, p. 34.
  9. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  10. ↑ Lua error in package.lua at line 80: module 'strict' not found.

References

  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.

External links

Retrieved from "https://infogalactic.com/w/index.php?title=1937_Pattern_Web_Equipment&oldid=2432726"