7.92×33mm Kurz

From Infogalactic: the planetary knowledge core
(Redirected from 7.92 x 33 mm)
Jump to: navigation, search
7.92×33mm Kurz
German 7.92x33mm Kurz.jpg
German 7.92×33mm Kurz cartridge
Type Rifle
Place of origin  Germany
Service history
Used by  Nazi Germany
Wars World War II - present day
Production history
Designer Polte ammunition works, Magdeburg[1]
Designed 1938[1]
Specifications
Parent case 7.92×57mm[2]
Case type Rimless, bottleneck
Bullet diameter 8.22 mm (0.324 in)
Neck diameter 9.10 mm (0.358 in)
Shoulder diameter 11.40 mm (0.449 in)
Base diameter 11.94 mm (0.470 in)
Rim diameter 11.95 mm (0.470 in)
Rim thickness 1.30 mm (0.051 in)
Case length 33.00 mm (1.299 in)
Overall length 48.00 mm (1.890 in)
Case capacity 2.22 cm3 (34.3 gr H2O)
Rifling twist 240 mm (1 in 9.45 inch)
Primer type Berdan
Maximum pressure (C.I.P.) 340.00 MPa (49,313 psi)
Ballistic performance
Bullet weight/type Velocity Energy
8.0 g (123 gr) FMJBT 685 m/s (2,250 ft/s) 1,886 J (1,391 ft·lbf)
8.1 g (125 gr) Ball 685 m/s (2,250 ft/s) 1,909 J (1,408 ft·lbf)
Test barrel length: 419 mm
Source(s): "Cartridges of the World" [3]

The 7.92×33mm Kurz (designated as the 7.92 x 33 kurz by the C.I.P.)[4][5][6][7][8] is a rimless bottlenecked rifle cartridge developed in Nazi Germany prior to and during World War II. The ammunition is also referred to as 7.9mm Kurz (German: Kurz meaning short), 7.9 Kurz, or 7.9mmK, or 8×33 Polte. It was specifically intended for development of an automatic carbine (assault rifle). The round was developed as a compromise between the longer 7.92×57mm rifle and the 9×19mm Parabellum pistol rounds, and is known as an intermediate cartridge (German: Mittelpatrone).

Cartridge dimensions

The 7.92×33mm Kurz has 2.22 ml (34.3 grains H2O) cartridge case capacity. The exterior shape of the case was designed to promote reliable case feeding and extraction in assault rifles under extreme conditions.

7.92×33mm Kurz.jpg

7.92×33mm Kurz maximum C.I.P. cartridge dimensions. All sizes in millimeters (mm).

Americans would define the shoulder angle at alpha/2 ≈ 17.5 degrees. The common rifling twist rate for this cartridge is 240 mm (1 in 9.45 in), 4 grooves, Ø lands = 7.89 millimetres (0.311 in), Ø grooves = 8.20 millimetres (0.323 in), land width = 4.40 millimetres (0.173 in) and the primer type is Berdan or Boxer (in large rifle size).

According to the official C.I.P. (Commission Internationale Permanente pour l'Epreuve des Armes à Feu Portatives) rulings the 7.92×33mm Kurz can handle up to 340.00 MPa (49,313 psi) Pmax piezo pressure. In C.I.P. regulated countries every rifle cartridge combo has to be proofed at 125% of this maximum C.I.P. pressure to certify for sale to consumers.[4] This means that 7.92×33mm Kurz chambered arms in C.I.P. regulated countries are currently (2014) proof tested at 425.00 MPa (61,641 psi) PE piezo pressure.

Military designation

In German military instructions, the caliber was often deemed unimportant; the name was emphasized. The 7.92×33mm "Kurz"[5][6][7][8] was referred to as the Pistolenpatrone M43 (pistol cartridge model 1943), Pistolen-Munition M43 (pistol ammunition model 1943), part of the same duplicity under which the StG44 was originally designated as a "machine pistol" to disguise the true nature of the weapon from Hitler; after the eventual approval and acceptance of the Sturmgewehr 44, it was redesignated the "short cartridge model 1943" (German: Kurzpatrone 43).

Background

The cartridge was the same caliber, and had the same base diameter, as the 7.92×57mm,[2] which was employed by the standard German Army infantry rifle, the Karabiner 98k, as well as its machine guns. The German armed forces had issued a 7.92×57mm automatic (select fire) rifle, the FG 42, in limited numbers, but the heavy recoil of the round made it difficult to use efficiently in this role.

What was needed was a cartridge that could be used in a lighter, more maneuverable rifle to bridge the gap between submachine guns and rifles. The standard issue 7.92×57mm cartridge case was shortened by 24mm. With a case length of only 33 mm, the Kurz round was substantially shorter and delivered less recoil than full-length 7.92×57mm, but was still as almost as effective when engaging targets at typical combat ranges of 300 m (328 yd). This meant it could be fired effectively from a weapon that weighed less than a machine gun, yet still had much greater range, velocity, and stopping power than the 9mm Parabellum which was standard in German submachine guns. The lighter weight meant that a soldier could carry more rounds of ammunition as well, for sustained suppressive fire.

The shortage of brass in the later stages of World War II led to the use of steel cases for this new cartridge. The Kurz cartridge incorporated more taper than the parent case because steel is less elastic than brass and more difficult to extract (and because the fact that the cartridge retained the same base diameter and caliber as the longer, full size round, requiring a more abrupt taper). This led to the distinctive curved magazine for weapons that used this cartridge, which became popularly known as banana clips, due to their curved shape, and which can be seen on other weapons using tapered cartridges, like the Kalashnikov rifle. The steel cases were typically lacquer-coated to prevent corrosion. The weight of the 7.92mm Kurz S.m.E. round was 17.05 grams, the bullet taking up 8.1 grams and the cartridge and powder the remaining 8.95 grams.[9]

Firearms

Prior to the development of the Kurz round and its associated weapons, two basic small arms existed to equip the regular infantryman, the bolt-action rifle and the submachine gun. The bolt-action rifle was the standard small arm for most of the worlds armies, usually incorporating good accuracy and stopping power, but with a very limited rate of fire. The submachine gun was a newer piece of equipment, which offered a very high rate of fire, and a compact size, but was of very limited range and stopping power due to the pistol round (usually 9mm) it fired. While the Kurz round did not match the range and accuracy of a full power round fired by a traditional bolt-action rifle, it could still engage individual targets out to 300 m (328 yd). As an effective, intermediate-sized cartridge, the Kurz round was a key evolution in the development of the assault rifle by providing a combination of controllable automatic fire and acceptable accuracy at ranges most likely to see infantry combat.[10][11][12][13]

Only a few weapons used this round, most notably the Sturmgewehr 44 and the Volkssturmgewehr 1-5. A number of weapons in development at the time also used the cartridge, including the Sturmgewehr 45, HIW VSK, Wimmersperg Spz-kr; and a number of German and Czech [14] prototype weapons made during World War II and a small number of prototype weapons made in other countries after the war. An unknown number of late-war K43 rifles were chambered for this cartridge and modified to accept MP 44 magazines.[15] Variants of the VK 98 (Volks-Karabiner), a so-called last-ditch bolt-action rifle intended for the Volkssturm Home Guard, were also chambered this cartridge with unknown quantities produced by Mauser[16] and Steyr.[17]

Post-World War II

After World War II, the cartridge was tested and used in prototype rifles in Argentina and Belgium, amongst other nations, during the late 1940s and early 1950s. The first FN FAL prototype was designed to fire the cartridge when NATO was organized. After the war it was manufactured by East Germany (the GDR), Czechoslovakia (ČSSR), and Egypt.

Spain continued development after the war, creating a few variants of the cartridge, such as tracer rounds, boat-tailed rounds and slightly shorter bullets that have a lead core. These developments were encouraged by Calzada Bayo, a Spanish lieutenant colonel.[18] However, they were cancelled and Spanish CETME rifles were chambered for a variant of the 7.62×51mm NATO round.

Demand for the ammunition still exists, as the StG 44 is still in use by some within the Lebanese Forces militia,[19] as well as irregular forces in some countries in the Horn of Africa and the Middle East, where captured German arms were distributed as military aid by Eastern Bloc countries as well as Yugoslavia. It is currently manufactured by the Prvi Partizan factory in Užice, Serbia.[20] There is also some demand on the private collectors' market; reloadable cartridge cases can be produced by resizing and trimming 7.62×51mm NATO cases, and Hornady makes a 125-grain .323-inch (8.2 mm) bullet for this caliber suitable for handloads.

In Pakistan, the same cartridge is also reported to be in use by the local name of "44 Bore." This either refers to the "44" of the MP44/StG44 series or the "L44A1" inscription found on the headstamps on necked-down 7.62×51mm cartridge cases. It is used in locally made AK-pattern weapons in semi-automatic only (produced or converted in Peshawer, Kohat and Derra Adam Khel, etc.) that chamber this cartridge, since 7.62×39mm is a restricted caliber (known as Prohibited Bore or "PB" in Pakistan). These AK-pattern weapons are usually considered inferior due to inconsistent gunsmithing of weapons chambered or converted for this cartridge and lack of quality control of the ammunition.[21] It is sometimes used by private security companies. The usage of 7.92 mm bullets in 7.62 mm barrels without reboring is not considered to be a safe practice.[22]

See also

References

  1. 1.0 1.1 Lua error in package.lua at line 80: module 'strict' not found.
  2. 2.0 2.1 Military Small Arms Of The 20th Century, 2000 by Ian V. Hogg & John S. Weeks, Page 221,243-245, 407
  3. Lua error in package.lua at line 80: module 'strict' not found.
  4. 4.0 4.1 C.I.P. TDCC datasheet 7,92 x 33 kurz
  5. 5.0 5.1 Small Arms Review, Vol. 7 No. 4, January, 2004 | Small arms Review refers to this cartridge only as 7.92×33mm Kurz
  6. 6.0 6.1 Jane's Guns Recognition Guide, Ian Hogg & Terry Gander, Harper & Collins Publishers, 2005, Page 287 refers to this cartridge only as 7.92×33mm Kurz
  7. 7.0 7.1 Barnes, Frank C. (1997) [1965]. McPherson, M.L.. ed. Cartridges of the World (8th Edition ed.). DBI Books. pp. 294, 311. ISBN 0-87349-178-5. | Cartridges of the World refers to this cartridge only as 7.92×33mm Kurz
  8. 8.0 8.1 Lua error in package.lua at line 80: module 'strict' not found.
  9. http://home.scarlet.be/p.colmant/polte-k.htg/draw02.jpg
  10. Jane's Guns Recognition Guide, Ian Hogg & Terry Gander, HarperCollins Publisher, 2005, p.287
  11. Lua error in package.lua at line 80: module 'strict' not found.
  12. Military Small Arms Of The 20th Century, 7th Edition, 2000 by Ian V. Hogg & John S. Weeks, p.243
  13. Major Thomas P. Ehrhart Increasing Small Arms Lethality in Afghanistan: Taking Back the Infantry Half-Kilometer. US Army. 2009
  14. Lua error in package.lua at line 80: module 'strict' not found.
  15. Senich, Peter R. The German Assault Rifle, 1935–1945, Paladin Press, Boulder, Colo., 1987, P. 147
  16. Walter, John, Guns of the Third Reich, Greenhill Books, London and Stackpole Books, Pennsylvania, 2003[page needed]
  17. Senich, Peter R. The German Assault Rifle, 1935–1945, Paladin Press, Boulder, Colo., 1987, PP. 168-170
  18. Lua error in package.lua at line 80: module 'strict' not found.
  19. Lua error in package.lua at line 80: module 'strict' not found.
  20. Lua error in package.lua at line 80: module 'strict' not found.
  21. Lua error in package.lua at line 80: module 'strict' not found.
  22. Lua error in package.lua at line 80: module 'strict' not found.

Further reading

  • Kapell, Dr. Dieter, Die deutsche Kurzpatrone 7,92×33, Books on Demand GmbH, Norderstedt Germany, 2007
  • Handrich, Hans-Dieter, Sturmgewehr! From Firepower to Striking Power, Collector Grade Publications Inc., Cobourg, Canada, 2004