Alberta clipper

From Infogalactic: the planetary knowledge core
(Redirected from Alberta Clipper)
Jump to: navigation, search
Average trajectory of a Clipper

An Alberta clipper (also known as a Canadian Clipper) is a fast moving low pressure area which generally affects the central provinces of Canada and parts of the Upper Midwest and Great Lakes regions of the United States, precipitating a sudden temperature drop and sharp winds.[1] Most clippers occur between December and February, but can also occur occasionally in November. Alberta clippers take their name from Alberta, Canada, the province from which they appear to descend, and from clipper ships of the 19th century, one of the fastest ships of that time.[2]

Formation

Typical winter storm tracks in Minnesota.

A clipper originates when warm, moist winds from the Pacific Ocean come into contact with the mountains in the provinces of British Columbia and then Alberta.[1][3] The air travels down the lee side of the mountains, often forming a chinook in Alberta, then develops into a storm over the Canadian prairies when it becomes entangled with the cold air mass that normally occupies the region in winter. The storm then slides southward and gets caught up in the jet stream, sending the storm barreling into central and eastern areas of North America.[4]

Ironically, the chinook which in part originates the Alberta clipper usually brings relatively warm weather (often approaching 10C/50F in the depths of winter) to southern Alberta itself, and the term is therefore not used in Alberta.

Effects

The storms sweep in at high speed over whatever land they encounter, usually bringing with them sharp cold fronts and drastically lower temperatures. It is not uncommon for an Alberta clipper to cause temperatures to drop by 16 °C (30 °F) in as little as 10 to 12 hours. Often, the storms bring biting winds with them, only increasing the effect of the lower temperatures. Winds in advance of and during an Alberta clipper are frequently as high as 56 to 72 km/h (35 to 45 mph). These conditions would cause wind chill values to drop into the -30 to -45 Celsius (-20 to -50 Fahrenheit) range.[4]

Snowfall amounts with these systems tend to be small (on the order of 1 to 3 inches or 2.5 to 7.5 cm), as the relative lack of moisture and quick movement inhibit substantial snowfall totals. However, several factors could combine to produce higher snow accumulations (6 inches/15 cm or more). These factors include access to more moisture (which raises precipitation amounts), slower system movement (which increases snowfall duration), and colder temperatures (which increases the snow to water ratio). The southern and eastern shores of the Great Lakes often receive enhanced snowfall from Alberta clippers during the winter, due to lake enhancement. The lake-effect snow can add substantially to the overall snowfall total.[4]

Occasionally the clippers, when reaching the Atlantic seaboard (usually between the Virginia and New England coasts), 'bomb out' and can cause severe winter weather along the coast as Atlantic moisture is tapped. Snowfall amounts can approach 6"-12" or more when this happens.

During the winter, Alberta clippers can occur somewhat frequently, with system intervals on the order of two to four days common during active periods.

Variations

Three variations of Alberta clippers are Manitoba mauler, Ontario scary-o, and Saskatchewan screamer.[5][6] These three types of systems are far less common than clippers, and even when they take place they are still often referred to as clippers. The main difference among the four is from which Canadian province they begin their southward trek.[7]

See also

North American weather patterns

References

  1. 1.0 1.1 Lua error in package.lua at line 80: module 'strict' not found.
  2. Lua error in package.lua at line 80: module 'strict' not found.
  3. Lua error in package.lua at line 80: module 'strict' not found.
  4. 4.0 4.1 4.2 Lua error in package.lua at line 80: module 'strict' not found.
  5. Lua error in package.lua at line 80: module 'strict' not found.
  6. Lua error in package.lua at line 80: module 'strict' not found.
  7. Lua error in package.lua at line 80: module 'strict' not found.

Further reading

  • Williams, Jack: The Weather Book, 1997, Vintage Books, ISBN 0-679-77665-6.
  • Dunlop, Storm: The Weather Identification Handbook: The Ultimate Guide for Weather Watchers, 2003, The Lyons Press, ISBN 1-58574-857-9.

External links