Caproni Campini N.1
<templatestyles src="Module:Hatnote/styles.css"></templatestyles>
| Caproni Campini N.1 | |
|---|---|
 |
|
| A Caproni Campini N.1 in flight | |
| Role | |
| Manufacturer | Caproni |
| First flight | 27 August 1940 |
| Status | Prototype |
| Number built | 2 |
| Variants | Caproni Campini Ca.183bis |
The Caproni Campini N.1, also known as the C.C.2, was an experimental aircraft built by the Italian aircraft manufacturer Caproni. The N.1 was powered by a motorjet, a type of jet engine that powers the compressor using a conventional aircraft engine. The N.1 first flew in 1940, and as news of the Heinkel He 178's flight in 1939 had not yet been made public, the FAI listed the N.1 as the first successful jet-powered aircraft.[1] The N.1 was the only model in the series.
Contents
Design and development
In 1931, Italian engineer Secondo Campini submitted a report on the potential of jet propulsion to the Regia Aeronautica, and demonstrated a jet-powered boat in Venice the following year. In 1934, the Regia Aeronautica granted approval for the development of a jet aircraft to demonstrate the principle.[citation needed]
As designed by Campini, the aircraft did not have a jet engine in the sense that we know them today. Rather, a conventional 900 hp (670 kW) Isotta Fraschini L.121 RC.40 12-cylinder liquid-cooled piston engine was used to drive a three-stage variable-incidence compressor, which forced air into a combustion chamber where it was mixed with fuel and ignited.[2] The exhaust produced by this combustion was to drive the aircraft forward. Campini called this configuration a "thermojet," but the term "motorjet" is in common usage today. It has also been described as a ducted fan.[3]
The relatively small duct resulted in low mass flow, and thus low propulsive efficiency. In modern designs this is offset through high overall pressure ratios, but the N.1 had a low pressure ratio and thus low thermal efficiency as well. As a result, the engine had relatively low thrust, about 1,550 lbf,[citation needed] and very poor fuel economy.[4]
Operational history
Campini turned to the Caproni aircraft factory to help build the prototypes, and two aircraft and a non-flying ground testbed were eventually constructed. The first flight from Caproni's Taliedo factory took place on 27 August 1940 with test pilot Mario De Bernardi at the controls. He reported reaching 225 mph at "barely half throttle".[citation needed] De Bernardi would do most of the flying of the N.1[5] As the August 1939 flight of the Heinkel He 178 V1 was still unknown at this time, the Fédération Aéronautique Internationale recognized this at the time as the first successful flight by a jet aeroplane.[citation needed]
On 30 November 1941 an N.1 flew from Milan's Linate Airport over Pisa and then landed at Rome's Guidonia Airport. The pilots, De Bernardi and Giovanni Pedace, were met by Benito Mussolini, as well many members of the press and aeronautical establishment. The 320 mile flight was promoted as the first cross-country flight by a jet aircraft, as well as the first jet-mail delivery.[citation needed] However, during the flight the combustion chamber was never operated in order to save fuel, thus the aircraft used the propulsion given by the ducted fan more than the propulsion given by the exhaust gasses.[6]
Following World War II, one of the prototypes was shipped to the United Kingdom for study at the Royal Aircraft Establishment at Farnborough.[citation needed]
Operators
Survivors
The prototype taken to the United Kingdom for tests subsequently disappeared. The other prototype is now on display at the Aeronautical Museum of Vigna di Valle near Rome and the ground testbed (fuselage only, and in very poor condition) is at the Museum of Science and Technology in Milan.
Specifications
Data from Illustrated Encyclopedia of Aircraft [7]
General characteristics
- Crew: two
- Length: 13.10 m (43 ft)
- Wingspan: 15.85 m (52 ft)
- Height: 4.7 m (15 ft 5 in)
- Wing area: 36.00 m² (387.5 ft²)
- Empty weight: 3,640 kg (8,024 lb)
- Max. takeoff weight: 4,195 kg (9,250 lb)
- Powerplant: 1 × 670 kW Isotta Fraschini liquid-cooled V12 engine motorjet, resulting in 6.9 kN (1,550 lbf)
- Piston engine drove a three-stage axial compressor for the thermojet with variable pitch vanes
Performance
- Maximum speed: 375 km/h (233 mph)
- Service ceiling: 4,000 m (13,300 ft)
See also
- Aircraft of comparable role, configuration and era
- Related lists
References
- Notes
- ↑ Enzo Angelucci; Paolo Matricardi. Campini Caproni C.C.2 in Guida agli Aeroplani di tutto il Mondo. Mondadori Editore. Milano, 1979, Vol. 5, pp. 218-9.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Marc de Piolenc and George Wright, "Ducted Fan Design", Marc de Piolenc, 2001
- ↑ Italian "Air Scooter" Flight, 10 October 1952 p. 471
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- ↑ Lua error in package.lua at line 80: module 'strict' not found.
- Bibliography
- Morse, Stan. Illustrated Encyclopedia of Aircraft, Orbis Publishing, 1982.
- Flight 1942 "Features of the Caproni Campini"
External links
 |
Wikimedia Commons has media related to Caproni Campini N.1. |
- Articles with unsourced statements from February 2014
- Articles with unsourced statements from October 2013
- Pages with broken file links
- Commons category link is defined as the pagename
- Caproni aircraft
- Italian experimental aircraft 1940–1949
- Motorjet-powered aircraft
- Low-wing aircraft
- World War II Italian experimental aircraft
- World War II jet aircraft of Italy
