Great Artesian Basin

From Infogalactic: the planetary knowledge core
Jump to: navigation, search
File:Great Artesian Basin.png
Great Artesian Basin in Australia
Lightning Ridge bathing thermes supplied by artesian bore water
Hot water bore hole into the Great Artesian Basin in Thargomindah

The Great Artesian Basin, located within Australia, is the largest and deepest artesian basin in the world, stretching over 1,700,000 square kilometres (660,000 sq mi), with measured temperatures ranging from 30–100 °C (86–212 °F). The basin provides the only reliable source of fresh water through much of inland Australia.[1]

The Basin underlies 23% of the continent, including the states and territories of Queensland (most of), the Northern Territory (the south-east corner of), South Australia (the north-east part of), and New South Wales (northern part of). The basin is 3,000 metres (9,800 ft) deep in places and is estimated to contain 64,900 cubic kilometres (15,600 cu mi) of groundwater.[2] The Great Artesian Basin Coordinating Committee (GABCC)[3] coordinates activity between the various levels of government and community organisations.

Physiography

This area is one of the distinct physiographic provinces of the larger East Australian Basins division, and includes the smaller Wilcannia Threshold physiographic section.

Geology

The water of the GAB is held in a sandstone layer laid down by continental erosion of higher ground during the Triassic, Jurassic, and early Cretaceous periods. During a time when much of what is now inland Australia was below sea level, the sandstone was then covered by a layer of marine sedimentary rock shortly afterward, which formed a confining layer, thus trapping water in the sandstone aquifer. The eastern edge of the basin was uplifted when the Great Dividing Range formed. The other side was created from the landforms of the Central Eastern Lowlands and the Great Western Plateau to the west.

Most recharge water enters the rock formations from relatively high ground near the eastern edge of the basin (in Queensland and New South Wales) and very gradually flows toward the south and west.[4] A much smaller amount enters along the western margin in arid central Australia, flowing to the south and east. Because the sandstones are permeable, water gradually makes its way through the pores between the sand grains, flowing at a rate of one to five metres per year.

Discharge water eventually exits through a number of springs and seeps, mostly in the southern part of the basin. The age of the groundwater determined by carbon-14 and chlorine-36 measurements combined with hydraulic modelling ranges from several thousand years for the recharge areas in the north to nearly 2 million years in the south-western discharge zones.[5]

Water source

Prior to European occupation, waters of the GAB discharged through mound springs, many in arid South Australia. These springs supported a variety of endemic invertebrates (molluscs, for example), and supported extensive Aboriginal communities and trade routes.[6] After the arrival of Europeans, they enabled early exploration and faster communications between southeastern Australia and Europe via the Australian Overland Telegraph Line.[6] The Great Artesian Basin became an important water supply for cattle stations, irrigation, and livestock and domestic usage, and is a vital life line for rural Australia.[7] To tap it, water wells are drilled down to a suitable rock layer, where the pressure of the water forces it up, mostly without pumping.

The discovery and use of water held underground in the Great Artesian Basin opened up thousands of square miles of country away from rivers in inland New South Wales, Queensland, and South Australia, previously unavailable for pastoral activities. European discovery of the basin dates from 1878 when a shallow bore near Bourke produced flowing water. There were similar discoveries in 1886 at Back Creek east of Barcaldine, and in 1887 near Cunnamulla.[7][8]

In essence, water extraction from the GAB is a mining operation, with recharge much less than current extraction rates. In 1915, there were 1,500 bores providing 2,000 megalitres (1,600 acre·ft) of water per day, but today the total output has dropped to 1,500 megalitres (1,200 acre·ft) per day.[2] This included just under 2000 freely flowing bores and more than 9000 that required mechanical power to bring water to the surface. Many bores are unregulated or abandoned, resulting in considerable water wastage. These problems have existed for many decades, and in January 2007 the Australian Commonwealth Government announced additional funding in an attempt to bring them under control. However, many of the mound springs referred to above have dried up due to a drop in water pressure, probably resulting in extinction of several invertebrate species.[9][10]

The Olympic Dam mine in South Australia is permitted to extract up to 42 million litres of water daily from the Great Artesian Basin under the Roxby Downs (Indenture Ratification) Act 1982. The underground copper and uranium mine commenced operations in 1988 and is expected to continue operating until approximately 2060.

In addition, the basin has provided water via a 1.2 km (0.75 mi) deep bore for a geothermal power station at Birdsville. The heated water is 98 °C (208 °F) and provides 25% of the town's needs. Ergon Energy is expanding the 80 kW plant to completely meet Birdsville's electricity requirements.[citation needed]

Extraction in South Australia

Extraction from the GAB in South Australia takes the following forms (in order of volume taken): vertical leakage, pastoral bores, natural springs, the Olympic Dam mine, gas and petroleum industry and the Roxby Downs township.[11]

Great Artesian Basin water usage in South Australia
Source Megalitres per day
Vertical leakage
215
Pastoral bores
130
Mound springs
66
Olympic Dam mine
32
Gas and petroleum industry
22
Roxby Downs township
3

Whole of Basin management

As the Great Artesian Basin underlies parts of Queensland, New South Wales, South Australia and the Northern Territory, which each operate under different legislative frameworks, policies and resource management approaches, a coordinated "whole-of-Basin" approach to the management of this important natural resource is required. The Great Artesian Basin Coordinating Committee (GABCC) provides advice from community organisations and agencies to State, Territory and Australian Government Ministers on efficient, effective and sustainable whole-of-Basin resource management and to coordinate activity between stakeholders.

Membership of the Committee comprises all State, Territory, and Australian Government agencies with responsibilities for management of parts of the Great Artesian Basin, community representatives nominated by agencies; and sector representatives.

The GABCC website provides up-to-date information and links to other sites that discuss the Basin can be accessed from there.[3]

Current scientific thinking

A comprehensive background to the Great Artesian Basin, including an overview of the nature of the Basin, the extraction of water and the impacts of that extraction, can be found in the Great Artesian Basin Resource Study, developed by the GABCC to support the Great Artesian Basin Strategic Management Plan.

Potential depletion and pollution due to coal seam gas extraction

In 2011, ABC TV Four Corners revealed that significant concerns were being expressed about depletion and chemical damage to the Basin as a result of coal seam gas extraction. In one incident, reported in the program, the Queensland Gas Company (QGC) fracked its Myrtle 3 well connecting the Springbok aquifer to the coal seam below (the Walloon Coal Measures) in 2009. A local farmer was concerned that the process may have released 130 litres (29 imp gal; 34 US gal) of a potentially toxic chemical into the Basin. QGC admitted the incident, but "did not alert authorities or nearby water users about the problem until thirteen months after the incident."[12] The safety data sheet QGC had submitted for the hydraulic fracturing chemical was derived from the United States, incomplete and ten years out of date.[12] Over thirty chemicals may be used in the process of hydraulic fracturing and their long-term impact on aquifers and the agriculture and people supported by them is unknown.[13]

See also

References

  1. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  2. ↑ 2.0 2.1 Lua error in package.lua at line 80: module 'strict' not found.
  3. ↑ 3.0 3.1 GABCC website
  4. ↑ http://www.gabcc.org.au/tools/getFile.aspx?tbl=tblContentItem&id=96 page 40 Archived 4 February 2014 at the Wayback Machine
  5. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  6. ↑ 6.0 6.1 Harris, Colin (2002). Culture and geography: South Australia’s mound springs as trade and communication routes, Historic Environment, 16 (2), 8-11. ISSN 0726-6715.
  7. ↑ 7.0 7.1 Lua error in package.lua at line 80: module 'strict' not found.
  8. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  9. ↑ Ponder, Winston. Mound Springs in Arid Australia, Australian Museum.
  10. ↑ Artesian springs ecological community - endangered ecological community listing - final determination, NSW Scientific Committee, Minister for the Climate Change and the Environment, New South Wales Government. Gazetted 15 June 2001. Page updated 12 February 2008.
  11. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  12. ↑ 12.0 12.1 Lua error in package.lua at line 80: module 'strict' not found.
  13. ↑ Lua error in package.lua at line 80: module 'strict' not found.

External links

Retrieved from "https://infogalactic.com/w/index.php?title=Great_Artesian_Basin&oldid=36852"