Jacksonville Skyway

From Infogalactic: the planetary knowledge core
(Redirected from JTA Skyway)
Jump to: navigation, search
Jacksonville Skyway
250px
Overview
Type Automated people mover
Status Operational
Locale Jacksonville, Florida
Termini Convention Center (west)
Kings Avenue (south)
Rosa Parks Transit Station (north)
Stations 8
Operation
Opened 1989
Operator(s) JTA
Character Elevated
Technical
Line length 2.5 mi (4.0 km)
Track gauge Monorail
Operating speed 35 mph (56 km/h)
Route map

The Jacksonville Skyway is a people mover in Jacksonville, Florida, United States. It is an automated monorail train operated by the Jacksonville Transportation Authority (JTA). Opening in 1989 with three stations in Downtown Jacksonville, the Skyway was extended in 1996 following a conversion from its original technology to Bombardier Transportation equipment. It was expanded again in 1998 and 2000. The system currently comprises two routes across 2.5-mile (4.0 km) of track, serving eight stations, and crosses the St. Johns River on the Acosta Bridge. There is currently no fare to ride the Skyway, which had 1.2 million passengers in 2014.

Description

File:Jacksonville Skyway stub.jpg
Skyway track curve between Central and Hemming Park stations at Hogan Street

The Skyway runs on an elevated two-way monorail track. The 2.5-mile (4.0 km) system serves eight stations in Downtown Jacksonville: five in the Downtown Core and LaVilla areas, and three across the St. Johns River on the Southbank. There are two routes running south from Rosa Parks Transit Station and branching at Central station: one going west and terminating at Convention Center station, and the other going south over the river and terminating at Kings Avenue station on the Southbank.[1][2]

The system has used two car and control systems since its creation. From 1989 to 1996 it had a system designed by Matra using its VAL 256-type rubber-wheeled technology. This ran only on the 0.7-mile (1.1 km), three station Phase I-A segment. In 1997, this was replaced by the current system designed by Bombardier Transportation, a version of its UM III monorail technology and 2 VAL cars were sold to O'Hare International Airport Transit System. In the current system, vehicles run on beams 34 inches (86 cm) wide and 28 inches (71 cm) deep, fixed on an 11-foot (3.4 m) wide guideway with parapet walls.[1][2] Each train is automated by Automatic Train Control (ATC), can have two to six cars, and travels at up to 35 mph (56 km/h) per hour.

History

Planning and development

An automated people mover for Downtown Jacksonville was first proposed in 1972 to deal with traffic and parking issues in the urban core. In 1976, the city incorporated the system into its mobility plan, hoping to attract interest from the Urban Mass Transit Administration's Downtown Peoplemover Program. The initial study was undertaken by the Florida Department of Transportation and Jacksonville's planning department, who took the Skyway project to the Jacksonville Transportation Authority (JTA) in 1977 for further development. Early proposals recommended a comprehensive system over 4 miles (6.4 km) long that would connect into adjacent neighborhoods, but the project's route and scope were greatly reduced over the years to meet budget constraints and the UMTA's parameters.[2][3]

After several stops and starts, the UMTA selected Jacksonville as one of seven cities to receive federal funding for the "Automated Skyway Express" in 1985. Two other related projects are Miami's Metromover and Detroit's People Mover. UMTA's approved plan called for the construction of a 2.5-mile (4.0 km) Phase I system to be built in three segments; the agency awarded JTA $23.5 million for the initial 0.7-mile (1.1 km) Phase I-A segment.[2][3]

Implementation and expansion

In July 1987, JTA selected French company Matra to build the Phase I-A segment. Work completed in May 1989 at a cost of $34.6 million. At its opening the Skyway served three stations on its east-west route: Central, Jefferson, and Terminal Station (now Convention Center station) on the Northbank of Downtown Jacksonville. Subsequent extensions were planned to take the Skyway north to Florida Community College at Jacksonville (FCCJ), and then south across the St. Johns River over the Acosta Bridge. Development of these routes began in 1992 and 1995, respectively, but negotiations for a new contract with Matra failed when the previous one expired. In October 1994 Bombardier Transportation was awarded a new contract to revamp the existing east-west segment with new technology and to complete the remaining Phase I extensions.[1][2]

The system was shut down on December 15, 1996 to replace the former Matra technology with Bombardier equipment; the older cars were sold to O'Hare International Airport in Chicago. The northbound extension was completed, adding the Hemming Plaza and Rosa Parks Transit Station stops, and the Skyway reopened on December 15, 1997, with service from the Prime F. Osborn III Convention Center to FCCJ. The southern segment opened on October 30, 1998, adding service to San Marco Station on Jacksonville's Southbank. On November 1, 2000, the Riverplace and Kings Avenue Stations opened, completing the Southbank segment and Phase I of the Skyway.[1]

Use and future

Ridership on the Skyway has been far below initial projections; while JTA originally anticipated 100,000 riders monthly, it averaged less than a third of that by 2009. The primary reasons are the decline of the downtown workforce and lack of connections to other neighborhoods and modes of transit. The system became a major point of contention in Jacksonville, with critics considering it a "ride to nowhere" and a waste of resources. In 2010, after underperforming for over twenty years, The Florida Times-Union called it "a Jacksonville joke for a generation". However, others argued that expansion of the system and downtown revitalization could make it a success.[3][4]

In February 2012, the Skyway was temporarily made free to ride until a new payment system was installed. Ridership jumped 61%—to 481,000 annually. Ridership in 2013 averaged nearly 4,000 on weekdays (the system is closed on weekends except for special events) and JTA has renewed the fare-free policy through the end of 2016.[5] In light of this momentum, JTA Director Nat Ford has announced the agency will apply for grants to expand the system with a new station in the fast-growing Brooklyn neighborhood.[6][7]

Stations

The Jacksonville Skyway has eight stations on two lines: the Northbank (Convention Center) line, and the Southbank (Kings Avenue) line. All trains run though Rosa Parks Transit Station, Hemming Park station, and Central station, where they split.[1]

Station Line(s) Location Opened Connections
Rosa Parks Transit Station Lua error in package.lua at line 80: module 'strict' not found.
Lua error in package.lua at line 80: module 'strict' not found.
201 West Union Street, Jacksonville 1997 Local Transit JTA Bus
(18 bays)
Hemming Park Lua error in package.lua at line 80: module 'strict' not found.
Lua error in package.lua at line 80: module 'strict' not found.
301 Hogan Street, Jacksonville 1997
Central Lua error in package.lua at line 80: module 'strict' not found.
Lua error in package.lua at line 80: module 'strict' not found.
300 West Bay Street, Jacksonville 1989
(rebuilt in 1997)
Intercity Bus Greyhound
Local Transit JTA Bus
BSicon BOOT.svg Water Taxi
Jefferson Lua error in package.lua at line 80: module 'strict' not found. 800 West Bay Street, Jacksonville 1989
(rebuilt in 1997)
Convention Center Lua error in package.lua at line 80: module 'strict' not found. 1101 West Bay Street, Jacksonville 1989
(rebuilt in 1997)
Local Transit JTA Bus
San Marco Lua error in package.lua at line 80: module 'strict' not found. 701 San Marco Boulevard, Jacksonville 1998 Local Transit JTA Bus
BSicon BOOT.svg Water Taxi
Riverplace Lua error in package.lua at line 80: module 'strict' not found. 801 Flagler Avenue, Jacksonville 2000 BSicon BOOT.svg Water Taxi
Kings Avenue Lua error in package.lua at line 80: module 'strict' not found. 1003 Kings Avenue, Jacksonville 2000 Local Transit JTA Bus

See also

References

  1. 1.0 1.1 1.2 1.3 1.4 Lua error in package.lua at line 80: module 'strict' not found.
  2. 2.0 2.1 2.2 2.3 2.4 Lua error in package.lua at line 80: module 'strict' not found.
  3. 3.0 3.1 3.2 Lua error in package.lua at line 80: module 'strict' not found.
  4. Lua error in package.lua at line 80: module 'strict' not found.
  5. Lua error in package.lua at line 80: module 'strict' not found.
  6. Lua error in package.lua at line 80: module 'strict' not found.
  7. Lua error in package.lua at line 80: module 'strict' not found.

External links

Lua error in package.lua at line 80: module 'strict' not found.

pt:Metrô de Jacksonville