Logic probe

A logic probe is a hand-held pen-like test probe used for analyzing and troubleshooting the logical states (Boolean 0 or 1) of a digital circuit. While most are powered by the circuit under test, some devices use batteries. They can be used on either TTL (transistor-transistor logic) or CMOS (complementary metal-oxide semiconductor) integrated circuit devices.

There are usually three differently-colored LEDs on the probe's body:

• Red and green LEDs indicate high and low states respectively
• An amber LED indicates a pulse (as used in a NOID Light to test for pulses to fuel injectors on an electronically controlled fuel injection vehicle)

The pulse-detecting electronics usually has a pulse-stretcher circuit so that even very short pulses become visible on the amber LED. A control on the logic probe allows either the capture and storage of a single event or continuous running.

File:Logic probe new.jpg

A low-cost logic probe

When the logic probe is either connected to an invalid logic level (a fault condition or a tri-stated output) or not connected at all, none of the LEDs light up.

Another control on the logic probe allow selection of either TTL or CMOS family logic. This is required as these families have different thresholds for the logic-high (V_IH) and logic-low (V_IL) circuit voltages.

Some logic probes have a separate audible tone for each of the logical states. An oscillating signal causes the probe to alternate between high-state and low-state tones.

A logic probe is a cheap, versatile and convenient digital test instrument, but can test only a single signal at a time. When many logic levels need to be observed or recorded simultaneously, a logic analyzer is used.

External links

• Schematic of a Simple Logic Tester
• Howto make the Simplest Logic Tester
• Howto make a Logic tester using a 555 timer chip