PACTOR

From Infogalactic: the planetary knowledge core
Jump to: navigation, search

PACTOR is a radio modulation mode used by amateur radio operators, marine radio stations, and radio stations in isolated areas to send and receive digital information via radio. A robust network of PACTOR stations has been established to relay data between radio stations and the Internet, extending Internet access to sea based and other isolated users.[1] PACTOR utilizes a combination of simple FSK modulation, and the ARQ protocol for robust error detection and data throughput. Generational improvements to PACTOR include PACTOR II, PACTOR III, and PACTOR IV which are capable of higher speed transmission. Pactor modes subsequent level 1 (P1) are not open source and therefore cannot be decoded by anyone who hasn't invested in a proprietary modem.

History

PACTOR (Latin: The mediator) was developed by Special Communications Systems GmbH (SCS) and released to the public in 1991. It was developed in order to improve the reception of digital data when the received signal was weak or noisy. PACTOR is an evolution of both AMTOR and packet radio; its name is a portmanteau of these two technologies. PACTOR combines the bandwidth efficiency of packet radio with the error-correction (CRC) and automatic repeat request (ARQ) of AMTOR. Amateur radio operators were instrumental in developing and implementing these digital modes. PACTOR is most commonly used on frequencies between 1 MHz and 30 MHz.

Current uses

PACTOR is a set of standardized modes used by Amateur and Marine radio operators for FSK radioteletype transfer of digital information over shortwave bands.

PACTOR radio equipment consists of an HF transceiver, a computer and a terminal node controller. Software running on the computer drives the terminal node controller. The most commonly used Amateur program for this purpose is Airmail.

PACTOR is used by Amateur Bulletin Board operators to exchange public messages, and open conversations across the world. It is also used by the NTSD (digital) portion of the ARRL's National Traffic System (NTS) to pass digital ARRL Radiograms. Newer PACTOR modes are used to transfer large binary data files and Internet E-mail, particularly via the Winlink global E-mail system.

The SailMail network transfers E-mail on behalf of Marine stations.[2]

Technical characteristics

HF data transmission by radio amateurs uses medium power (100 watts) over long distances (100 to 4000 km). Effective radio-frequency communications over such long distances over hostile radio paths require that special attention be paid to the rate at which data is repeated and error correction. To reduce the amount of data sent, on-line data compression is utilized, along with memory ARQ error correction. By combining these open technologies, PACTOR achieves a power efficiency much greater than that of older protocols such as packet, AMTOR, or RTTY. PACTOR has a very narrow waveform and occupies the same band space as analog 300 baud packet.

PACTOR utilizes very rapid Time-Division Duplexing, giving PACTOR communications its characteristic cricket-like chirping sound when listened through a single-sideband receiver.

Depending on the version of PACTOR protocol used and the radio-frequency conditions, PACTOR transmission speeds range from 20 to 5200 bits per second (bit/s; net rate) or 9000 bit/s gross rate utilizing speed 10 (32-QAM).[3][4]

The ITU Emission Designators:

  * Pactor I is 304HF1B.
  * Pactor II is 375HJ2D (at a symbol rate of 100 symbols per second).[5]
  * Pactor III is 2K20J2D (at a symbol rate of 100 symbols per second).[5][6]
  * Pactor IV is 2K40J2D (at a symbol rate of 1800 symbols per second).[4]

Criticism

Cost is an important consideration when choosing PACTOR equipment. PACTOR I is open technology and modems can be purchased in the $50–$150 price range and are in ample supply. The two enhanced modes, PACTOR II and PACTOR III, are much faster but have been kept proprietary by the German company, SCS, that developed them. As a result, SCS is the only source for modems capable of these modes. The price of these modems—in some cases as much as a HF radio—discourage many potential users.[7]

Like all digital radio modulation modes, PACTOR transmissions have the potential to disrupt other modes of communication on the same or nearby frequencies. Radio operators using PACTOR are encouraged to follow "good operating practices" to ensure that they do not interfere with other stations. In certain configurations, Pactor II, III and IV utilize a proprietary data compression technology. As the data is compressed, and the decompression algorithm is not publicly known, the contents of PACTOR transmissions are unreadable to anyone without a PACTOR capable terminal node controller.

See also

References

  1. Lua error in package.lua at line 80: module 'strict' not found.
  2. Lua error in package.lua at line 80: module 'strict' not found.
  3. 4.0 4.1 Lua error in package.lua at line 80: module 'strict' not found.
  4. 5.0 5.1 Lua error in package.lua at line 80: module 'strict' not found.
  5. Lua error in package.lua at line 80: module 'strict' not found.
  6. Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.

External links