Short Kent

From Infogalactic: the planetary knowledge core
Jump to: navigation, search
S.17 Kent
Kent2179y.jpg
Role Biplane Flying Boat Airliner
Manufacturer Short Brothers
First flight 24 February 1931
Introduction 1931
Retired 1938
Primary user Imperial Airways
Produced 1930-1931
Number built 3
Developed from Short Calcutta
Variants Short Scylla

The Short S.17 Kent was a British four-engined 15-seat biplane luxury flying boat airliner, designed and built by Shorts to meet a requirement from Imperial Airways for an aircraft with greater range than the Short Calcutta. The new aircraft was to have sufficient range to fly the stage from Mirabella, Crete, to Alexandria in Egypt without the need for refuelling stops in Italian colonial territory due to a political row which had led the Italian Government to ban British aircraft from its ports.

Three aircraft were built, each receiving its own name: Scipio, Sylvanus and Satyrus; they were referred to collectively within Imperial Airlines as the Scipio Class flying boats. Each had an aircrew of three (two pilots and a radio operator/navigator) and a steward to prepare meals and light refreshments for the passengers.

Design and development

[1][2] The Short Kent flying boat was essentially an enlarged, four-engined version of the Calcutta, with the same passenger carrying capacity but with an increased payload for mail and fuel. It was powered by four Bristol Jupiter XFBM radial engines mounted on vertical struts between the upper and lower planes.

The wings were constructed using corrugated duralumin box spars, tubular rib assemblies, with a fabric covering and Frise ailerons on upper and lower wings.[3] Duralumin walkways were provided to allow ready access to the engines for maintenance purposes. The tail unit consisted of braced monoplane horizontal and vertical stabilizers; the tailplane was fitted with Flettner-type servo tabs for trimming[4] on the Short Scylla which had the same wings and tail as the Kent.

The anodised duralumin fuselage was mounted below the lower wing, with the planing bottom of the hull made of stainless steel (as on the Singapore II) with a transverse main step. The use of stainless steel reduced the frequency of land inspections of the hull. The bimetallic corrosion problems experienced on the Singapore II hull had been solved; Short Brothers became the first company to master the technique of building seaplane floats and flying-boat hulls in this combination of metals.

A quick-release hook (controlled by the pilots) was provided, which enabled the captain to start, warm up and (when required) run all four engines up to full power for take-off while the aircraft was still attached to the mooring buoy.

Maximum comfort was required for passengers and crew: the Kent's passenger cabin was 8 ft 6 in (2.59 m) wide and 14 ft (4.27 m) long. The seating was arranged in four rows of facing pairs, with a centre aisle, Pullman style. The steward's pantry, situated on the port side aft of the passenger cabin, was equipped with twin-burner oil stoves on which stewards (and the valets of valued passengers) could cook meals in flight. The toilet and washroom were opposite the pantry; the mail and freight compartment was further aft.

Special attention was paid to sound levels in the passenger cabin and crew's stations; accordingly the engines were fitted with exhaust collector rings and long tail pipes, to reduce exhaust noise inside the hull.

The cockpit, for two pilots, was fully enclosed (unlike that of the Calcutta's) with a separate Radio Officer's station directly aft of the cockpit.

Service history

In October 1930, Short Brothers started building the first of the three S.17 Kent flying-boats (G-ABFA, named Scipio). It was launched and flown on 24 February 1931 by Shorts' Chief Test Pilot J. Lankester Parker and was in service in the Mediterranean in May of that year. The second (G-ABFB, named Sylvanus) was launched on 31 March 1931; the third Kent (G-ABFC, Satyrus) was launched on 30 April 1931 and flown for the first time on 2 May 1931.

Imperial Airways used the Kent aircraft on the Mediterranean stages of its routes to India and beyond, also using them to survey planned routes to South Africa and Australia.[5]

On 22 August 1936 "Scipio", on its way back from India, flipped over and sank in "Mirabella Harbour" (between the mainland and the island of Spinalonga) after landing heavily,[6] killing the two crew members.[7] Sylvanus was destroyed by fire at Brindisi on 9 November 1935,[8] killing all on board. Only Satyrus survived to be taken out of service and scrapped in June 1938.[9]

In 1933 Imperial Airways placed an order for two landplanes based on the Kent; known initially as the S.17/L and later as the L.17, these became the Short Scylla, of which two were built and given the names "Scylla" and "Syrinx".

Operators

 United Kingdom

Specifications

Data from British Civil Aircraft 1919-1972 [10]

General characteristics

  • Crew: 4
  • Capacity: 16
  • Length: 78 ft 5 in (23.91 m)
  • Wingspan: 113 ft 0 in (34.45 m)
  • Height: 28 ft 0 in (8.51 m)
  • Wing area: 2,640 ft² (245 m²)
  • Empty weight: 20,460 lb (9,300 kg)
  • Loaded weight: 32,000 lb (14,545 kg)
  • Powerplant: 4 × Bristol Jupiter XFBM air-cooled radial piston engine, 555 hp (414 kW) each

Performance

See also

Related development

References

Notes
  1. Cassidy, p.20ff.
  2. Barnes and James, p.272ff.
  3. Barnes and James p.226 and p.269.
  4. Short Scylla[not in citation given]
  5. http://www.openthebook.com/pdfs/ports_sample.pdf Image (on p.25) shows a Short Kent on the Sea of Galilee (in or after 1931)
  6. Lua error in package.lua at line 80: module 'strict' not found.[dead link]
  7. Lieut. Richard Glen Wilson-Dickson and Thomas Alexander Cecil "Whimmie" Forbes.
  8. http://www.planecrashinfo.com/1935/1935-32.htm Information w.r.t. the loss of "Sylvanus" at Brindisi, 1935.[not in citation given]
  9. Barnes and James, p.272.
  10. Jackson 1988, p.140.
  11. Flight 19 August 1932, p.781.
Bibliography
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.
  • Lua error in package.lua at line 80: module 'strict' not found.[dead link]
  • Lua error in package.lua at line 80: module 'strict' not found.[dead link]

External links