Saddle (landform)

The Relationship of Saddles between each pair of Mountain Peaks

The two Saddles between each pair of Mountains A cross-section diagram of three hills, with two saddles marked by X.  • There are three peaks (Schartenhöhe) or prominences shown labeled 'A', 'B', & 'C'.  • The diagram illustrates the topographic isolation (German: Dominanz)-the distance from a prominence which is also a minimum to the point of the same height.  • The 'isolation' (German: Dominanz) of the right two peaks is not labeled, but is represented by the dashed line.  • 'sattel zwischen' literally means saddle between so the labeling is saying the Saddle between A and C is the same saddle as between A and B

The saddle between two hills (or mountains) is the region surrounding the highest point of the lowest point on the line (tracing the drainage divide, the Col) connecting the peaks. When, and if, the saddle is navigable, even if only on foot, the saddle of a (optimal) pass between the two massifs, is the area generally found around the lowest route on which one could pass between the two summits, which includes that point which is a mathematically when graphed a relative high along one axis, and a relative low in the athwart axis, simultaneously; that point being by definition the Col of the saddle.

In plain language, a saddle is the lowest area between two highlands (prominences or peaks) but has two wings which span the divide (the line between the two prominences) by crossing the divide at an angle, so is concurrently the local highpoint of the land surface which falls off in the down direction. That is, the drainage divide is a ridge along the high point of the saddle, as well as between the two peaks so defines the major reference axis. A saddle can vary from a sharp narrow gap to a broad comfortable sway-backed shallow valley so long as it is both the high point in the sloping faces descending to lower elevations and the low area between the two (or three or four.) flanking summits. Concurrently, along a different axis, it is the low point between two peaks, so is the likely 'optimal' high point in a pass if the saddle is traversed by a track, road or railway.

Road beds, Cols and placements

Note, a road bed through a pass need not be through a Col (so will then have to be along a traverse face of one peak or the other, and the road bed will be cutting across the divide at nearly ninety degrees), but by not encompassing the Col, mathematically requires the road bed be above the altitude of the Col.

Minima and Maxima in a mathematics modeled in 3D form a 'saddle' when a point that is a relative maxima is also a relative minima in another axial orientation. Saddles have Cols The distinction between a saddle and a col is always clear by keeping in mind the Col will always be the lowest point on the Saddle co-linear with the drainage divide that connects the peaks. Whittow describes a saddle as "low point or col on a ridge between two summits", whilst the Oxford Dictionary of English implies that a col is the lowest point on the saddle. Monkhouse describes a saddle as a "broad, flat col in a ridge between two mountain summits." The term col tends to be associated more with mountain, rather than hill, ranges. The height of a summit above its highest saddle (called the key saddle) is effectively a measure of a hill's prominence, an important measure of the independence of its summit. Saddles lie on the line of the watershed between two hills.

(Click for full screen image)  • The map has been annotated with Purple arrows illustrating DOWN slopes for those unfamiliar with reading Topographic maps. Note the watercourses cut into the slopes creating a succession of Vee shaped notches. One of many places where this is shown is the arrow marked -L-.  • There are white 'trails' illustrating how one might walk pushing a cart—some of these take a shallow angle across the terrain, a Traverse as does the railroad labeled with -T-. This diagram is labeled to illustrate a variety of landforms in a natural terrain setting.  • The points -A-, -B-, -C-, -D- and, -E- all represent Saddles-relative minimums oriented to two or more nearby peaks, but a local maxima relative to lower (low land places) one might wish to go or come from.  • The center-bottom point -E looms over two very steep slopes, so is unlikely to be used as a pass, save for mountaineers, and certainly not for transportation infrastructure. This makes it easy to classify as a Col, a non-pass, but still a saddle.  • Toward the bottom left is -P' with an elevation annotation—these illustrate how the USGS denotes a prominence (peaks, and usually the highest on a ridgeline) on a map.

(Click on THIS FULL map to see the full map of the topological map example extract above.)