NZASM 13 Tonner 0-4-0T

From Infogalactic: the planetary knowledge core
Jump to: navigation, search
NZASM 13 Tonner 0-4-0T
300px
13 Tonner, c. 1889
Type and origin
Power type Steam
Designer Maschinenfabrik Esslingen
Builder Maschinenfabrik Esslingen
Serial number 2311
Build date 1889
Total produced 1
Specifications
Configuration 0-4-0T (Four-coupled)
Driver axle 2nd coupled axle
Gauge 3 ft 6 in (1,067 mm) Cape gauge
Coupled dia Lua error in Module:Convert at line 452: attempt to index field 'titles' (a nil value).
Wheelbase 5 ft 3 in (1,600 mm)
Length:
 • Over couplers
Lua error in Module:Convert at line 452: attempt to index field 'titles' (a nil value).
Height 11 ft 2 in (3,404 mm)
Frame type Plate
Adhesive weight Lua error in Module:Convert at line 1851: attempt to index local 'en_value' (a nil value).
Loco weight Lua error in Module:Convert at line 1851: attempt to index local 'en_value' (a nil value). w/o
Fuel type Coal
Fuel capacity 5 long hundredweight (0.3 t)
Water cap 300 imp gal (1,400 L)
Boiler:
 • Pitch
Lua error in Module:Convert at line 452: attempt to index field 'titles' (a nil value).
 • Diameter Lua error in Module:Convert at line 452: attempt to index field 'titles' (a nil value).
 • Tube plates Lua error in Module:Convert at line 452: attempt to index field 'titles' (a nil value).
 • Small tubes 88: Lua error in Module:Convert at line 452: attempt to index field 'titles' (a nil value).
 • Firebox type Round-top
Boiler pressure 160 psi (1,103 kPa)
Firegrate area 7.1 sq ft (0.66 m2)
Heating surface 305 sq ft (28.3 m2)
 • Tubes 271 sq ft (25.2 m2)
 • Firebox 34 sq ft (3.2 m2)
Cylinders Two
Cylinder size 11 in (279 mm) bore
Lua error in Module:Convert at line 452: attempt to index field 'titles' (a nil value). stroke
Valve gear Allan
Valve type "D" slide
Couplers Bell link-and-pin
Performance figures
Tractive effort 5,150 lbf (22.9 kN) @ 75%
Career
Operators NZASM
Class NZASM 13 Tonner
Number in class 1
Official name 13 Tonner
Delivered 1889
First run 1889

The NZASM 13 Tonner 0-4-0T of 1889 was a South African steam locomotive from the pre-Union era in the Transvaal.

In 1889, the Nederlandsche-Zuid-Afrikaansche Spoorweg-Maatschappij acquired a single locomotive, very similar to its 14 Tonner locomotives and built by the same manufacturer, but with a smaller water and coal capacity. Since the railway classified its locomotives according to their weight, this well-and-side-tank locomotive would have been known as the 13 Tonner.[1]

The Randtram line

As a result of the rapid development of the goldfields on the Witwatersrand in the 1880s and the demand for coal by the growing industry, the Volksraad of the Zuid-Afrikaansche Republiek (ZAR), also known as the Transvaal Republic, granted a concession to the Nederlandsche-Zuid-Afrikaansche Spoorweg­maatschappij (Netherlands-South African Railway Company, NZASM) on 20 July 1888, to construct a 16 miles (26 kilometres) long railway line from Johannesburg to Boksburg. The line, which was opened on 17 March 1890, became known as the "Randtram" line, even though it was actually a railway in every aspect and not singularly dedicated to tram traffic. This was the first working railway line in the Transvaal.[1][2][3]

Manufacturer

In 1889, six small 0-4-0T tank locomotives were delivered to the NZASM by the German engineering firm and locomotive builder Maschinen­fabrik Esslingen, owned by Emil Kessler. Five of these were the NZASM 14 Tonners. The sixth, the sole 13 Tonner, was also a well-and-side-tank locomotive with a 0-4-0T wheel arrangement and was similar to, but lighter than the 14 Tonner.[1]

Characteristics

The engine's cylinders were arranged outside the plate frames. The "D" type slide valves, mounted above the cylinders, were arranged at an incline and were actuated by Allan straight link motion. In this type of valve gear, the valve rod and the expansion link are respectively connected to opposing arms on the reversing shaft, so that partial rotation of the shaft moves the link and the die block in opposite directions.[1]

Apart from the side-tanks, the locomotive also had a well-tank between the frames under the boiler barrel. The dome was on the front section of the boiler and the regulator valve was arranged in the smokebox.[1]

Comparison

Compared to the 14 Tonner, the 13 Tonner differed in at least three respects, judging from photographs. The 13 Tonner had a much narrower coal bunker and a shorter chimney. The side-tanks were also much smaller, reaching only as far forward as aft of the boiler-mounted sandbox dome.[1][3]

On the 14 Tonner, the side-tanks on each side are in two parts and reach as far forward as aft of the steam dome. In addition, the 14 Tonner had two small panels in the side of the rear tank on its right side. The 13 Tonner had no such panels.[1][3]

Illustration

The main picture of the 13 Tonner and those following of the 14 Tonner, serve to illustrate the differences between the 13 Tonner and the slightly larger 14 Tonner locomotive.

References

  1. 1.0 1.1 1.2 1.3 1.4 1.5 1.6 Espitalier, T.J.; Day, W.A.J. (1944). The Locomotive in South Africa - A Brief History of Railway Development. Chapter IV - The N.Z.A.S.M.. South African Railways and Harbours Magazine, October 1944. pp. 761-764.
  2. Lua error in package.lua at line 80: module 'strict' not found.
  3. 3.0 3.1 3.2 The South African Railways - Historical Survey. Editor George Hart, Publisher Bill Hart, Sponsored by Dorbyl Ltd., Published c. 1978, p. 19.